COMMAND CENTER Pages
ItemDescription
Kyocera Online http://www.kyoceramita.com/
Basic Page
This section includes settings that apply to the machine, such as Device Defaults, Security, and basic Networking. If the Admin password has been set, pages in this section are available only to the Administrator.
Basic > Defaults > Network
This page allows you to make the settings that are required for network printing and sending
You must restart this machine after you have completed these settings in order to properly register the content of those settings in the machine. Refer to Basic > Defaults
>Reset on page 9.
Item | Description |
|
|
Host Name | Specifies a name for the printing system network |
| component. This name is used as the NetBEUI printer name |
| and as the WSD device name. |
|
|
LAN Interface | Specifies the communication rate from Auto, |
|
|
| After you have changed this setting, you must restart this |
| machine. For the restarting procedure, refer to Basic > |
| Defaults > Reset on page 9. |
|
|
IPv4 Settings | Specifies whether or not to obtain an IP address using |
DHCP/ | |
BOOTP | DHCP or BOOTP. |
|
|
IP Address | Assigns the Internet Protocol address on the printing system |
(IPv4) | network component. Format of the IP address is |
| |
|
|
Subnet | Specifies the subnet mask of the hosts or network with which |
Mask | the print system is connecting. If you have manually |
| assigned an IP address that starts with a number between |
| 192 and 223, it is recommended that you set the subnet |
| mask to "255.255.255.0." |
|
|
Default | Specifies the IP address of the default gateway. |
Gateway |
|
|
|
IPv6 Settings | Specifies whether or not to enable the IPv6 protocol. |
IPv6 | |
| Select On to use the IPv6 protocol. |
|
|
IP | Assigns an IPv6 address to the printing system network |
Address | component. The format of the IPv6 address is a sequence of |
(IPv6) | numbers (128 bit in total) separated by colons, e.g. |
| 2001:db8:3c4d:15::1a2c:1a1f. |
|
|
Operation Guide | 7 |
