10.Position the new memory module over the memory slot. Ensure that the notch 1 on the memory module aligns correctly with the slot key 2 on the system board. Push the memory module straight down into the slot until the retaining clips close.
Figure 14. Installing a memory module
What to do next:
•To work with another piece of hardware, go to the appropriate section.
•To complete the installation or replacement, go to “Completing the parts replacement” on page 85.
Installing or replacing a PCI card
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to install or replace a PCI card. Your computer has two standard PCI card slots, one PCI Express x1 card slot, and one PCI Express x16 graphics card slot.
To install or replace a PCI card, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Open the computer cover. See “Opening the computer cover” on page 32.
3.Rotate the PCI card retainer to the open position.
4.Depending on whether you are installing or replacing a PCI card, do one of the following:
•If you are installing a PCI card, remove the appropriate metal slot cover.
•If you are replacing an old PCI card, grasp the old card that is currently installed and gently pull it out of the slot.
Chapter 5. Installing or replacing hardware 37
