Lenovo 2941 Replacing the microprocessor, What to do next, Installing the heat sink fan duct

11.Lower and position the heat sink fan duct on the top of the heat sink and fan assembly until it snaps into position.

Figure 52. Installing the heat sink fan duct

What to do next:

•To work with another piece of hardware, go to the appropriate section.

•To complete the replacement, go to “Completing the parts replacement” on page 85.

Replacing the microprocessor

Attention:

Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.

This section provides instructions on how to replace the microprocessor.

CAUTION:

The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five minutes to let the computer cool before removing the computer cover.

To replace the microprocessor, do the following:

1.Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect all power cords from electrical outlets and disconnect all cables that are connected to the computer.

2.Open the computer cover. See “Opening the computer cover” on page 32.

Chapter 5. Installing or replacing hardware 67