Installing the Ni-Cd Battery Pack
To use the battery pack, follow these steps:
1Make sure that the power switch of the
2Open the battery cover by gently pushing the two protruding clips as shown.
|
| Attention |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| ||
Do | not | insert | the | battery | pack | into | the | drive | with | ||||
the | polarity | reversed. |
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
Install | the | battery | pack | with | the | label | facing | upward. To | allow | ||||
for later | easy | removal | of | the | battery | pack, | extend | the | ribbon | ||||
below | the | battery | pack. | To remove | the | battery | pack, | lift | the | ||||
ribbon. |
|
|
|
|
|
|
|
|
|
|
|
| |
3Slide the battery pack into the drive.
The | positive end | (+) | of each battery has a protrusion. This end |
should | be opposite | the | springs. |
