Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR |
FAULT CODES | DESCRIPTION/ |
| RESOLUTION |
| DEFINITION |
|
|
0081 | Average motor over cur- | • | The wire drive motor has overheated. |
| rent shutdown | • | Check to make sure the electrode |
|
|
| slides easily through the liner of the |
|
|
| gun. |
|
| • | Reduce the spindle brake resistance. |
|
| • | Reduce the amount of tension in the |
|
|
| wire drive tension arm. |
|
| • | For the best results, use only Lincoln |
|
|
| electrodes. |
|
| • | Wait 10 minutes for the wire feeder to |
|
|
| cool. |
0082 | Locked rotor condition | • | Verify that nothing is jammed in the |
| on the wire drive motor. |
| wire drive or gears. |
0086 | Trigger lockout. | • | The ripple of the power source OCV |
|
|
| is too high, greater than 110V. |
|
|
| (Across the Arc Models only) |
|
| • | Verify that the power source is |
|
|
| reconnected for the proper input |
|
|
| voltage. |
|
| • | Repair or replace the power source. |
|
|
| The power source does not conform |
|
|
| to NEMA. |
NOTE: If more than one fault message is being displayed, perform all the checks for the faults
before replacing the printed circuit board
