Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR | ||
|
|
DRIVE MOTOR TEST (Continued)
Figure F.6- Motor Leads
LEADS 550 & 551
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TEST PROCEDURE
1.Remove the input power to the
2.Perform the Wire Drive Assembly
Removal procedure.
3.Locate the Positive lead 550 (white) and disconnect from motor. Note pin location for reassembly. See Figure F.6.
4.Locate the Negative lead 551 (gray) and disconnect from motor. Note pin location for reassembly. See Figure F.6.
5.Apply a variable DC voltage to the drive motor from lead 550(white)(+) to lead
6.When the supply voltage is varied from 3 to 26 VDC, the drive motor speed (RPM) should vary accordingly. If the motor does not run or vary in speed, the motor, gearbox or motor brushes may be faulty. Check or replace.
7.Check the resistance between each of the motor leads and the motor case. The resistance should be very high (at least 500,000 ohms). If the resistance is low, the motor is grounded to the motor case and should be replaced.
