OPERATION |
Return to Master TOC
Rotate the WFS knob until the desired parameter is displayed.
CV/CC Mode: 
WFS Units:
2.Activate and release the GAS PURGE switch to select the parameter. The present value will then display in the right hand side of the display. Example:
INTERNAL CONTROLS (Figure B.2)
| COLD FEED/ | 2 STEP/TRIGGER | |
| GAS PURGE | ||
| INTERLOCK | ||
| SWITCH | ||
SPRING | SWITCH | ||
| |||
TENSION |
| SPINDLE | |
ARM |
| BRAKE |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
3.Rotate the WFS knob to change the parameter set- ting.
WFS
CV/CC MODE:
•"CU" for Constant Voltage power sources
•"CC" for Constant Current power sources
WFS UNITS:
•"US" for in/min
•"Eur" for m/min
4.Press the GAS PURGE switch to save the setting. The
5.To exit the "Press Spin"
FLOWMETER
SPRING TENSION ARM
The pressure arm controls the amount of force the drive rolls exert on the wire. Proper adjustment of both pressure arm gives the best welding performance. For best results, set both pressure arms to the same value.
Set the pressure arm as follows (See Figure B.2a):
Aluminum wires | between 1 and 3 |
Cored wires | between 3 and 4 |
Steel, Stainless wires | between 4 and 6 |
Figure B.2a
CORED WIRES | 1 |
| SOLID WIRES |
OUTERSHIELD | 2 | ALUMINUM | |
3 |
| ||
METALSHIELD | 6 |
| |
| 5 |
| |
INNERSHIELD |
| 4 | STEEL |
|
|
| STAINLESS |
Return to Section TOC
Return to Master TOC
