Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR
WIRE DRIVE ASSEMBLY
REMOVAL AND REPLACEMENT PROCEDURE (Continued)
Figure F.13 - WIRE DRIVE MOUNTING SCREW LOCATION
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
REMOVAL PROCEDURE
1.Remove input power to the
2.Open door.
3.Remove the four screws mounting the wire drive assembly to the case. See Figure F.13.
4.Using small pliers disconnect the gas hose from the conductor block.
5.Carefully maneuver the drive assembly out of the case.
6.Using the 3/4” wrench remove the cable from the conductor block.
7.Remove lead 67 from the conductor block. See Wiring Diagram.
8.Remove plug J2.
MOUNTING SCREWS
REPLACEMENT PROCEDURE
1.Connect previously removed plug J2 to the new conductor block.
2.Replace lead 67 into the conductor block.
3.Replace the cable onto the conductor block.
4.Replace the gas hose onto the conductor block.
5.Carefully maneuver the Wire Drive Assembly into the case.
6.Secure assembly to machine using the four previously removed screws.
