Return to Section TOC
Return to Master TOC
TROUBLESHOOTING AND REPAIR |
CONTROL RELAY REPLACEMENT (continued)
FIGURE F.11 – CONTROL RELAY REPLACEMENT.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
CONTROL RETAINING
RELAY CLIP
REPAIR PROCEDURE
1.Remove the cover from the control box by removing the four 5/16 in. screws from the top and side of the unit.
2.Slide the retaining clip off the side of the control relay. See Figure F.11.
3.Remove the control relay by pulling out wile gently rocking from side to side.
4.Insert the new control relay by pressing in and rocking side to side. Do not press too hard on the relay as this may damage the control PC board.
5.Slide the retaining clip over the end of the control relay.
6.Reinstall the cover on the control box using four hex head screws.
Return to Section TOC
Return to Master TOC
CAUTION
Do not use excessive force when inserting control relay. Excessive force can damage the control PC board. If the control relay does not fit, remove it and try again.
