Return to Master
Return to Master TOC
Return to Master TOC
Return to Master TOC
7.Solder the two wires onto the new power resistor.
8.Install one insulating spacer onto the resistor mounting bolt. Install the power resistor and the second spacer onto the mounting bolt. Secure in place with a flat washer and hex nut.
9.If the wire feeder is equipped with a meter kit, install a second washer and
the meter cable strap. If a meter kit is not equipped, install only the second washer.
10.Install a third washer and a hex nut.
11.Reinstall the cover on the control box using four hex head screws.
