Return to Section TOC
Return to Section TOC
Section TOC
Return to Master TOC
Return to Master TOC
Master TOC
TROUBLESHOOTING AND REPAIR |
CIRCUIT BREAKER REPLACEMENT (continued)
FIGURE F.5 – CIRCUIT BREAKER AND PUSH BUTTON REPLACEMENT.
RETAINING
NUTS
CIRCUIT
BREAKER
PUSH BUTTON
Return to
Return to Section TOC
Return to
Return to Master TOC
REPAIR PROCEDURE
1.Remove the cover from the control box by removing the four 5/16 in. screws from the top and side of the unit.
2.Remove the two wires from the back of the circuit breaker. See Figure F.5.
3.Remove the retaining nut that secures the circuit breaker to the panel of the wire feeder. Remove the circuit breaker from the wire feeder.
4.Install the new circuit breaker through the panel of the control box. Secure the circuit breaker with the retaining nut.
5.Connect the two wires to the back of the circuit breaker.
6.Reinstall the cover on the wire feeder using four hex head screws.
