Master TOC
TROUBLESHOOTING AND REPAIR |
GROUND LEAD PROTECTOR
PUSH BUTTON SWITCH REPLACEMENT (continued)
Return to
Return to Master TOC
Return to Master TOC
Return to Master TOC
REPAIR PROCEDURE
1.Remove the cover from the control box by removing the four 5/16 in. screws from the top and side of the unit.
2.Remove the retaining nut from the front of the push button and remove the push button from the control box. See Figure F.5.
3.Unsolder the two leads from the back of the push button.
4.Solder the two leads onto the new push button.
5.Install the new push button through the case of the control box.
6.Install the retaining nut onto the front of the push button.
7.Reinstall the cover on the control box using four hex head screws.
