ACCESSORIES |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
SUBMERGED ARC GUNS
The K112 gun and cable assembly is recommended for welding with 1/16 in. solid steel electrode at up to 500 amps. The K113 gun and cable is recommended for 5/64 in. and 3/32 in. (2.0 and 2.4 mm) solid steel electrodes (types L50, L60, L61, and L70) for use up to 600 amps.
GMAW GUNS
An expanding line of Magnum GMA gun and cable assemblies are available to allow welding with solid and cored electrodes using the GMAW process. See the appropriate Magnum literature for descriptions of the
NOTE: Magnum GMA welding guns require a
K527 WATER SOLENOID KIT
Install and connect per the instructions (M16261) shipped with the kit.
This kit is factory installed on the
K376 AND K303 50 TO 60 LB WIRE REEL MOUNTING STANDS
The K376 50 to 60 lb Wire Reel Mounting Stand and the K303 Wire Reel Mounting Stand are the same with the exception that the K303 stand includes a dust shield. The assembly includes a framework to which is attached the 50 to 60 lb wire reel, a mounting spindle, a lift bale, and a cable clamp for fastening the input cable assembly. It is easily mounted to the basic wire feed unit by following the Attaching the Wire Reel Stand procedure at the end of this section.
ATTACHING THE WIRE REEL STAND
The mounting hardware for mounting the stands is included with the
1.Remove the three 3/8 in. hex head bolts from the back of the wire feed unit.
2.Place the wire reel mounting stand mounting bracket in position against the back of the wire feed unit.
3.Replace and tighten the hex head bolts. The long screw and plain washer go into the top hole.
