1. Introduction
The 24 + 2 Giga SNMP Ethernet Switch is a high performance web-managed SNMP Layer 2 switch that provides users with 24 10/100Mbps Ethernet ports and a single module port into which either 100BaseFX or Gigabit modules can be installed. Several optional modules are available in single or dual port configurations. The Switch has SNMP management and remote control capabilities. Gigabit modules, can be copper or fibre media types supporting 1000BASE-SX, 1000BASE-LX or 1000BASE-T, allowing users to increase their network response time at gigabit speeds and with great flexibility. An RS-232 serial port provides out of band configuration for the initial set-up.
Non-blocking,Maximum wire speed performance is achieved on all ports with support for Auto-Negotiation and Auto-MDIX functions on all switched 24 10/100M RJ-45 ports and both Gigabit Copper ports in both half or full duplex mode.
The 24 + 2 Giga SNMP Ethernet Switch provides convenient web browser management of its layer 2 features. The User-friendlydrop-down menu allows the user to easily learn, control and monitor the switch. It supports not only traditional SNMP functions, but also RMON 1,2,3,9 groups for advanced network analysis.
The Switch also supports both port-based and Tag-based VLAN’s, as well as Trunking on up to 4 ports at a time with 7 trunking groups. Trunked ports provide fail- over functionality, so that if one port fails a backup port can be added into the group.
The Front Panel Design provides a full LED status display to quickly diagnose port status or any potential problems. Extra LED’s are used to indicate fan status and avoid fan failures and over-heating issues.
1.1 Unpacking
Open the shipping carton of the Switch and carefully unpack its contents, the carton should contain the following items:
•1 x 24 + 2 Giga SNMP Ethernet Switch
•2 x 19” Mounting Brackets and Screws
•4 x Rubber Feet
•1 x Mains Cable
•1 x RS-232 Console Cable
•CD with LINDY Manual (English Only)
•LINDY Quick Installation Guide
1.2 Installation
Follow the guidelines below to install the Switch.
•Do not place any object weighted more than 3Kg (6.6 lb) on the Switch.
•Connect the power cord to the Switch and to a power outlet.
•Leave at least 10 cm (4 inches) of space around the Switch for heat dissipation.
-3 -
