Linksys Etherfast manual Serial Port Configuration, Snmp Configuration

EtherFast® Series

Serial Port Configuration

The Serial Port Configuration screen allows you to access the communication parameters for the Switch’s serial port.

•Baud Rate - The rate at which data is sent between devices. Default is 19200. Options are 9600, 19200, and 38400 baud.

•Data Bits - Sets the data bits of the RS-232 port. Options are 7 and 8.

•Stop Bits - Sets the stop bits of the RS-232 port. Options are 1 and 2.

•Parity - Sets the parity of the RS-232 port. Default is None. Options are none, odd, and even.

•Time-Out- If no input is received from the attached device after this interval, the current session is automatically closed. Default is 10 minutes. The range is 0 to 100 minutes, where 0 indicates disabled.

•Auto Refresh - Sets the interval before a console session will auto refresh the console information, such as Spanning Tree Information, Port Configuration, Port Statistics, and RMON Statistics. Default is 1 second. The range is 0, or 5 to 255 seconds, where 0 indicates disabled.

Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes.

EtherFast® Managed 24-Port with Dual Gigabit Switch

SNMP Configuration

The SNMP Configuration screen displays parameters for the Simple Network Management Protocol (SNMP).

•Send Authentication Fail Traps - Issue a trap message to specified IP trap managers whenever authentication of an SNMP request fails. Default is enabled.

•SNMP Communities - Assigns SNMP access based on specified strings.

•IP Trap Managers - Specifies management stations that will receive authentication failure messages or other trap messages from the Switch.

Select OK to return to the previous panel.

22 23