Subnet Information, ARP Table | Linksys Etherfast guide

EtherFast® Series

Subnet Information

The Subnet Information screen displays information about the IP interface for VLANs configured on this Switch.

•IP Address - The IP address associated with the specified VLAN inter- face.

•Subnet Mask - A template that identifies the address bits in the host address used for routing to specific subnets.

•VLAN - The VLAN associated with this IP interface.

•(Ports) - The ports on the Switch.

Read the numbers vertically; they range from 1-26. For each port number, there are two choices: “S” or “P.” Use the spacebar to scroll through the choices.

The letter “S” indicates a static entry.

The letter “P” indicates the port is a static entry, and the port’s PVID is set to this VLAN ID.

Select Apply to make changes. Select OK to return to the previous panel. Select Prev Page to view the previous page. Select Next Page to view the next page. To display a specific page, set the page number in the Page field and then press Apply.

EtherFast® Managed 24-Port with Dual Gigabit Switch

ARP Table

The ARP Table shows the IP-to-MAC addresses discovered by ARP.

•IP Address - IP addresses for which ARP has resolved the physical address through a broadcast message.

•MAC Address - MAC address that maps to the corresponding IP address.

•VLAN - The VLAN group this host has been assigned to.

•Port - The port this host device is attached to.

Select OK to return to the previous panel. Select First Page to view the first page. Select Next Page to view the next page.

82

83

Image 44

Linksys Etherfast manual Subnet Information, ARP Table

Contents

EtherFast Managed 24-Port With Dual Gigabit Switch Copyright & Trademarks Table of Contents Introduction LEDs Getting to Know the SwitchPackage Contents Console Port RJ-45 PortsGigabit Ports Installing the Switch Pre-Installation ConsiderationsRack-Mounting the Switch Powering on the Switch Switch Management Overview Web Management Main Menu Configuring the SwitchLogging On to the Switch System Information Menu System Information Switch Information Management Setup Menu Network Configuration IP Configuration Http Configuration IP Connectivity Test Ping Serial Port Configuration Snmp Configuration Snmp Communities IP Trap Managers User Configuration Add User Configuration File Tftp Download Device Control Menu System Mode Layer 2 Menu Port Configuration Mirror Port Configuration Port Trunking Configuration Static Unicast Address Configuration Static Multicast Address Configuration Add Static Address Entry Add Multicast Address Entry Bridge Menu Bridge Configuration Spanning Tree Port Configuration Vlan Port Configuration Vlan Menu Vlan Table Configuration Vlan and Priority Subnet Configuration IP Menu Protocol Configuration Add Subnet ARP Configuration RIP Configuration Static ARP Table Bootp Relay Database ConfigurationAdd Bootp Relay Server Add Static ARP Entry Static Route Table Default Route Menu Add Routing Entry MAC Filtering Configuration Security Menu Security Mode IP Security Filtering ConfigurationAdd MAC Address Filter Add IP Address Filter Igmp Snooping Configuration Network Monitor Menu Interfaces Group Port Statistics/Statistics MenuPort Statistics Ethernet-Like Rmon Statistics Layer 2 Address Table Spanning Tree Bridge Information Spanning Tree Port Information Vlan Information Vlan Dynamic Registration Information Vlan Forwarding Information IP Multicast Registration Table Subnet Information ARP Table Routing Table Multicast Table Menu Igmp Cache Multicast Forwarding Cache Dvmrp Routing Table Dvmrp Neighbor Table System Restart Menu Exit TroubleshootingCommon Problems and Solutions Tion Upgrading Firmware via the Serial Port Your firmware has now been updatedAppendix Glossary 101 103 Environmental SpecificationsWarranty Information Tech Support RMA Issues Fax Contact InformationSales Information Web FTP Site T p / / w w w. l i n k s y s . c o m