Web Management | Linksys Etherfast specs

EtherFast® Series

4.When the following screen appears, make sure that the Switch’s serial port settings are as follows:

BAUD RATE: 19200

DATA BITS: 8

PARITY: None

STOP BITS: 1

FLOW CONTROL: None

Click the OK button.

Web Management

Web management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Use a standard Web browser (Internet Explorer 4.0 or above, or Netscape Navigator 4.0 or above is suggested) from any computer attached to the network. The Switch has a default IP address of 192.168.1.254 and a default subnet address of 255.255.255.0.

EtherFast® Managed 24-Port with Dual Gigabit Switch

Telnet Management

Telnet management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Use telnet from any computer attached to the network.

SNMP/RMON Management

SNMP/RMON management is available after the Switch has been configured with a valid IP address, subnet mask, and default gateway (for Layer 2 mode) via the console interface. Manage the Switch from any network computer using network management software.

Note: The Switch’s configuration program only provides access to basic configuration functions. To access the full range of SNMP management functions, you must use SNMP-based network management software.

10

11

Image 8

Linksys Etherfast manual Web Management

Contents

EtherFast Managed 24-Port With Dual Gigabit Switch Copyright & Trademarks Table of Contents Introduction LEDs Getting to Know the SwitchPackage Contents Console Port RJ-45 PortsGigabit Ports Installing the Switch Pre-Installation ConsiderationsRack-Mounting the Switch Powering on the Switch Switch Management Overview Web Management Main Menu Configuring the SwitchLogging On to the Switch System Information Menu System Information Switch Information Management Setup Menu Network Configuration IP Configuration Http Configuration IP Connectivity Test Ping Serial Port Configuration Snmp Configuration Snmp Communities IP Trap Managers User Configuration Add User Configuration File Tftp Download Device Control Menu System Mode Layer 2 Menu Port Configuration Mirror Port Configuration Port Trunking Configuration Static Unicast Address Configuration Static Multicast Address Configuration Add Static Address Entry Add Multicast Address Entry Bridge Menu Bridge Configuration Spanning Tree Port Configuration Vlan Port Configuration Vlan Menu Vlan Table Configuration Vlan and Priority Subnet Configuration IP Menu Protocol Configuration Add Subnet ARP Configuration RIP Configuration Static ARP Table Bootp Relay Database ConfigurationAdd Bootp Relay Server Add Static ARP Entry Static Route Table Default Route Menu Add Routing Entry MAC Filtering Configuration Security Menu Security Mode IP Security Filtering ConfigurationAdd MAC Address Filter Add IP Address Filter Igmp Snooping Configuration Network Monitor Menu Interfaces Group Port Statistics/Statistics MenuPort Statistics Ethernet-Like Rmon Statistics Layer 2 Address Table Spanning Tree Bridge Information Spanning Tree Port Information Vlan Information Vlan Dynamic Registration Information Vlan Forwarding Information IP Multicast Registration Table Subnet Information ARP Table Routing Table Multicast Table Menu Igmp Cache Multicast Forwarding Cache Dvmrp Routing Table Dvmrp Neighbor Table System Restart Menu Exit TroubleshootingCommon Problems and Solutions Tion Upgrading Firmware via the Serial Port Your firmware has now been updatedAppendix Glossary 101 103 Environmental SpecificationsWarranty Information Tech Support RMA Issues Fax Contact InformationSales Information Web FTP Site T p / / w w w. l i n k s y s . c o m