EtherFast® Series
priority, the port with the lowest numeric identifier will be enabled. The range is
•Cost - This parameter is used by the STA algorithm to determine the best path between devices. Therefore, lower values should be assigned to ports attached to faster media, and higher values assigned to ports with slower media. (This takes precedence over port priority.)
•Fast Forwarding - This parameter is used to enable/disable the Fast Spanning Tree mode for the selected port.
Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes. Select Prev Page to view the previous page. Select Next Page to view the next page.
VLAN Menu
The VLAN Menu is used to assign any port on the Switch to any of up to 256 VLAN groups. By using IEEE 802.1Q compliant VLANs, you can organize any group of network nodes into separate broadcast domains, confining broadcast traffic to the originating group. This also provides a more secure and cleaner network environment.
•VLAN Port Configuration - Configure GARP, the default VLAN identi- fier, default port priority, VLAN tagging on the attached link, GVRP and
EtherFast® Managed
GMRP status, and filtering of incoming frames for VLAN groups a spe- cific port does not belong to.
•VLAN Table Configuration - Use this screen to create a new VLAN or modify the settings for an existing VLAN.
Select OK to return to the previous panel.
VLAN Port Configuration
The VLAN Port Configuration screen allows you to configure GARP, the default VLAN identifier, default port priority, VLAN tagging on the attached link, GVRP and GMRP status, and filtering of incoming frames for VLAN groups a specific port does not belong to.
GARP
Group Address Registration Protocol is used by GVRP and GMRP to reg- ister or deregister client attributes for client services within a bridged LAN.
•Join Time - The interval (centiseconds) between transmitting requests/queries to participate in a group.
•Leave Time - The interval (centiseconds) a port waits before leaving a group. This time should be set to more than twice the Join Time. This
44 | 45 |
