Linksys Etherfast manual Troubleshooting, Exit, Common Problems and Solutions

EtherFast® Series

Exit

The Exit command under the Main Menu is used to exit the configuration program and terminate communications with the Switch for the current ses- sion.

If you need to return to the program, press Enter repeatedly.

EtherFast® Managed 24-Port with Dual Gigabit Switch

Troubleshooting

Common Problems and Solutions

This section provides possible solutions to problems regarding the installation and operation of the Managed 24-Port with Dual Gigabit Switch. If your situ- ation is described here, the problem should be solved by applying the corre- sponding solution. If you can’t find an answer here, check the Linksys web- site at www.linksys.com.

1.I can’t connect to the Managed 24-Port with Dual Gigabit Switch using the telnet, Web browser, or SNMP software.

•Be sure you have configured the agent with a valid IP address, subnet mask, and default gateway (Layer 2).

•Check that you have a valid network connection to the Switch and that the port you are using has not been disabled.

•Check the network cabling between the management station and the Switch.

•If you cannot connect using telnet, there may already be four active sessions. Try connecting again at a later time.

2.I forgot or lost the password.

•Reinstall the switch firmware as described in the Appendix. Otherwise, contact Linksys Technical Support for help.

92 93