EtherFast® Series
IP Menu
The IP Menu is used to configure the IP subnets for each VLAN on your Switch, the unicast and multicast routing protocols, and IGMP. This menu is only available for a Switch in multilayer mode.
•Subnet Configuration - Specifies the IP interface for VLANs configured on this Switch, including the subnet address and routing protocols.
•Protocol Configuration - Enables the unicast and multicast routing pro- tocols globally for this Switch.
•Static ARP Configuration - Specifies the static Address Resolution Protocol.
•Static Route - Configures a static route.
•Default Route - Defines the router to which this Switch will forward all traffic for unknown networks.
Select OK to return to the previous panel.
EtherFast® Managed
Subnet Configuration
The Subnet Configuration screen allows you to specify an IP interface for any VLAN configured on this Switch that needs to communicate with a device outside of its own group (that is, another network segment).
•IP Address - The IP address associated with the specified VLAN inter- face. By convention, the last three digits should be set to “254” to readily distinguish this device as a router port.
•Subnet Mask - A template that identifies the address bits in the host address used for routing to specific subnets. Each bit that corresponds to a “1” is part of the network/subnet number, and each bit that corresponds to “0” is part of the host number.
•VLAN - The VLAN associated with this IP interface.
•RIP - Routing Information Protocol for unicast routing.
•DVMRP -
Select Apply to make changes. Select OK to return to the previous panel. Select Cancel to cancel any changes. Select Prev Page to view the previous page. Select Next Page to view the next page. To display a specific page, set the page number in the Page field and then press Apply. Select Add to add an IP interface.
48 | 49 |
