Lorex 16 channel security dvr with 500GB hard drive, remote viewing To set up e-mail notification

Using the Main Menu

Adjusting remote connectivity streaming rates

You can adjust the data streaming rate (also called the SubStream) when you connect to the system remotely. If you want to conserve bandwidth, select a lower frame rate and bitrate.

NOTE: Setting your system to stream with a lower frame and bitrate may cause the video to appear choppy or slow.

To adjust the SubStream settings:

1Click the SubStream tab.

2Configure the following beside the desired channel:

•Video: Select Enabled or Disabled. If you selectDisabled,youwillnotbeabletoview the channel when connecting remotely to the system.

•FPS: Select the desired frames per second. Choose from 1~6 FPS.

•Bitrate: Select the desired video bitrate. Choose from 8, 16, 24, 32, 48 or 64 .

•Audio: Select or deselect the checkbox to enable or disable the system from streaming audio when viewing the system remotely.

3Click Apply to save your settings.

Setting up E-mail Notification

The system can send e-mail notifications when it detects motion, or when an alarm parameter triggers. The

16channel model sends e-mail notifications if an alarm block device triggers (i.e. motion sensor detects movement).

To set up e-mail notification:

1Click the Email tab in the Network menu.

2From the "Email" drop-down menu, select from:

•Enable: Uses custom e-mail server settings.

•Disable: Disables e-mail notification.

•Default: Uses the Lorex e-mail server to send out alarm notifications. This is the recommended selection.

If you select "Enable", and want to use your own e-mail server, configure the following:

•SSL: Select ON/OFF to enable/disable Secure Socket Layer protocol

•SMTP Port: Enter your SMTP address

•SMTP Server: Enter your SMTP Server

•Sender Email: Enter the sender e-mail address. This can be any address of your choice

38