Lorex 16 channel security dvr with 500GB hard drive, remote viewing Configuring Motion Settings

Using the Main Menu

Alarm

The Alarm tab allows you to configure Motion and Alarm settings.

Configuring Motion Settings

Configure motion settings to determine the area you wish to monitor for motion events, and the outcome if a motion event occurs.

To configure motion settings:

1From the main menu, click Alarm>Motion.

2Configure the following:

•Channel: Select the channel you wish to configure.

•Enable: Select Enable or Disable to activate or deactivate motion recording.

•Area: Click the Setup button to configure the area of the screenthat detects motion.

•Sensitivity: Select motion sensitivity. The greater the number, the greater the sensitivity.

•Alarm Out: Select the checkbox to enable the system to trigger a device connected to the alarm block.

•Latch Time: Enter the duration the alarm continues to trigger after the event ends.

•ShowMessage:Select the checkbox if you want the system to display a system message when an alarm triggers.

•Buzzer: Select the checkbox to enable the system to "beep" if an alarm triggers.

•Send Email: Select the checkbox if you want the system to send email notifications if an alarm triggers.

•Record Channel: Select the channel you wish the DVR to record during motion recording.

•Record Delay: Select the duration the system continues to record as an event after the alarm trigger ends. For example, if you select 30s (30 seconds), the system continues to record for 30 seconds after the alarm trigger ends.

•Full Screen: Select the Full Screen check boxsothatthesystemgoesintofullscreen mode when motion or an alarm trigger is detected.

•Post Recording: Enter the post recording duration (the time thesystem continuesto record after a motion event occurs).

3Click Apply to save your settings.

Drag mouse cursor over desired area

Drag the mouse cursor over the area you wish to monitor for motion. The grid turns from red to transparent.

Right-click to exit.

41