Transducer Frequency
This unit operates from both 200 kHz and 50 kHz. The default frequency is 200 kHz. It’s best for use in shallow water. The 50 kHz frequency is best for deep water, especially saltwater. Use the arrow keys to highlight the desired frequency, then press the ENT key to select it.
Surface Clarity
The markings extending downward from the zero line on the chart are called “surface clutter”. These markings are caused by wave action, boat wakes, temperature inversion, and more.
The surface clarity control reduces or eliminates surface clutter signals from the display. It does this by changing the sensitivity of the receiver, decreasing it near the surface and gradually increasing it as the depth increases. The maximum depth that the surface clarity control can affect is 75% of the selected depth range. For example, on a 0 - 60 foot range with surface clarity control set to high, surface clutter will be reduced down to 45 feet.
There are three levels of surface clarity available: low, medium, or high. It can also be turned off. The default level is low. To change it, highlight “Surface Clarity” on the “Sonar Features” menu, then press the ENT key to select it. Use the cursor keys to highlight the desired level of surface clarity, then press the ENT key.
Noise Rejection
The automatic noise rejection system built into this unit constantly evalu- ates the effects of boat speed, water conditions, and interference from electrical and mechanical sources such as bilge pumps, engine ignition systems and wiring, even engine vibration. It then works to reduce or eliminate the negative effects on the sonar screen. This gives the best display possible under most conditions.
The Noise Rejection system is an effective tool in combating noise. In sonar terms, noise is any undesired marks on the display.
This unit has two levels of noise rejection: normal and high. It can also be turned off. The default is normal. To change it, highlight “Noise Rejection” on the “Sonar Features” menu, then press the ENT key to select it. Use the cursor keys to highlight the desired level of noise rejection, then press the ENT key.
17
