Transducers (cont.) |
|
|
| Model | Part # |
200 kHz “Pod” Transducer | ||
w/o temp for |
|
|
50/200 kHz Dual Freq | ||
“Skimmer” High Speed |
|
|
Transom mount with |
|
|
temp sensor |
|
|
50/200 kHz Dual Freq | ||
Bronze |
|
|
w/temp and speed sensor |
|
|
INSTALLATION
Bracket
Install the unit in any convenient location, provided there is clearance behind it when it is tilted for the best viewing angle. Holes in the bracket base allow wood screw or
9.6” | 3.7” |
| 7.3” |
2.3”
Once the best location is determined, use the bracket as a template and mark the mounting holes and the hole for the cables. Drill a 1.0" hole for the cables. Screw the bracket to the mounting surface.
IMPORTANT!
In order to pass all connectors through the 1" hole in the bracket and dash, first pass the transducer connector up through the hole, then any accessory cables. Next, pass the power cable down through the hole. Fill the hole with a marine sealant. You can now wire the power cable.
2