![](/images/new-backgrounds/1255683/25568349x1.webp)
Transducer | Transducer | |
bracket | ||
|
Ratchet | Ratchet |
|
Add ratchets to bracket and transducer.
2.Aligning the transducer on the transom.
A.
If the transducer's face isn't parallel with the ground, remove the transducer and ratchets from the bracket. Place the ratchets into the holes in the bracket with the letter "B" aligned with the dot stamped in the bracket.
Reassemble the transducer and bracket and place them against the transom. Again, check to see if you can move the transducer so it's parallel with the ground. If you can, then go to step 3A. If it doesn't, repeat step 2A, but use a different alignment letter until you can place the transducer on the transom correctly.
Ratchets
Insert bolt and check transducer position on transom.
17