Lower Latch Assembly | Maytag MGR6775ADB/Q/S/W, MGR6875ADB/Q/S/W

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury, or death: disconnect electrical and gas supply before servicing.

Upper Oven Door

Lower Latch Assembly

NOTE: Removal of range from installation position is required.

1.Disconnect power before servicing.

2.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

3.Remove range from installation position, see "Move and/or Replacing Range" procedure.

4.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)

5.Remove left side panel, see "Side Panel" procedure.

6.Disconnect and label wiring from door lock switch and motor.

7.Remove screws securing latch assembly and slide assembly from range.

8.Reverse procedure to reassemble.

Upper Latch Assembly

1.Disconnect power before servicing.

2.Remove oven door, see "Oven Door(s)-Door Removal" procedure.

3.Remove maintop, see "Maintop Removal" procedure. (Perform steps 1 – 6.)

4.Disconnect and label wiring from door lock switch and motor.

5.Remove screws securing latch assembly and slide assembly from range.

6.Reverse procedure to reassemble.

©2004 Maytag Services

16023415

27

Image 27

Maytag MGR6775ADB/Q/S/W, MGR6875ADB/Q/S/W manual Lower Latch Assembly, Upper Latch Assembly

Contents

Service Important Information Customer Service Support Center Table of Contents Servicing Safety Practices for Servicer Receiving Oven Using the Oven Electrical Requirements Connecting Range to GasProduct Safety Devices Baking, Broiling, and Roasting General Information Parts and Accessories SpecificationsPlacement of the Oven Service Grounding Arning Range Description Troubleshooting Procedures 16023415 Maytag Services Maytag Services 16023415 Component Troubleshooting No gas flows to burner Ignitor glows red Check lamp and replace is necessary Testing Procedures Testing Procedures Illustration/Component Test Procedure H2 Control Testing Model MGR6875AA H3 Control Testing Model MGR6775AA Quick Test Mode for Electronic Range Control This mode will also display the current fault code for Leveling Legs Top Surface Valve and Spark SwitchTop Burner Lower Assembly Moving and/or Replacing Range Oven Doors Oven Light ReplacementOven Sensor Electronic Clock Gasket and Door Disassembly Upper Latch Assembly Lower Latch Assembly Gas Valve Convection AssemblyOven Door Hinge Regulator Oven Racks Oven Cavity Components GasRack Positions Appendix a Maytag Double Oven Gas Range Double Oven Gas Range Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions Appendix B Pilotless Ignition Suggested Heat SettingsOperating During a Power Failure Surface Controls To prevent the cooktop from discoloring or staining Surface Cooking To set the Clock To change the clock to 24-hour format Locking the Control Oven Doors TimerFault Codes Adjusting the Sound Level To set bake Return To Factory Default SettingsSetting Upper and Lower Oven Functions Baking Cook & Hold Delay Cook & Hold Keep Warm Adjusting the Oven TemperatureTo cancel Keep Warm To adjust the oven temperature To set Broil Broiling upper oven only Oven Bottom Automatic Shut-Off/Sabbath ModeOven Vent Oven Lights To replace oven racks Upper ovenLower oven To remove oven racks Surface Cooking Surface Cooking Using the Touchpads Control PanelClock Adjusting Sound Level Setting Oven Functions Baking with ConvectionTo set Convect Bake To set Convect Roast Roasting With Convection Broiling upper oven only Broiling Chart Broil times are based on a 5 minute preheat Oven Cooking To cancel a Favorite cycle in progress FavoriteTo start a cycle programmed into Favorite Sabbath Mode Notes Rack Positions lower oven Care & Cleaning Do not USE ANY Cleaning Product Containing Chlorine Bleach Appendix C LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions LP Conversion Instructions