Chapter 5 - Using SETUP

Password

Creates passwords at bootup for accessing SETUP values or disabling current passwords. There are two kinds of password, the bootup password and SCU (SETUP) password. To create or change these passwords, run SETUP and select Password under the Startup menu. The following dialog box appears:

Boot Password

Creates a password to access to the system at bootup, or disables the current password.

To create or change a password, enter 4 to 8 characters in the text box. Each character is displayed by an asterisk ( * ). Using the <Tab> key, highlight Enable password for Boot-up. When you press the <Spacebar>, an [X] appears. Press <Enter>. Next, reenter the password to verify it, then, press <Enter>. A message appears stating that the password has been verified, then tells you to press any key to continue. After the password dialog box closes, an [X] appears next to the Boot Password menu item.

Note: If you enter the wrong verification password, you’ll have to start again.

Removing the boot-up password

Highlight Enable password for Bootup and press <Spacebar>. The [X] mark goes away.

57

Page 57
Image 57
Micron Technology MERIDIAN 850 manual Boot Password