>Advanced setting > NAT setting > Port Redirection
Active Configuration
Items | Service name Protocol | Actual Port | Virtual IP | Virtual Port | Enable | |
1 | 1 | UDP | 5060 | 192.168.1.10 | 5060 | v |
2 | 2 | UDP | 16384 | 192.168.1.10 | 16384 | v |
3 | 3 | UDP | 16394 | 192.168.1.10 | 16394 | v |
4 | 4 | UDP | 5061 | 192.168.1.11 | 5061 | v |
5 | 5 | UDP | 26384 | 192.168.1.11 | 26384 | v |
6 | 6 | UDP | 26394 | 192.168.1.11 | 26394 | v |
7 |
| 0 |
| 0 | x | |
8 |
| 0 |
| 0 | x | |
9 |
| 0 |
| 0 | x | |
10 |
| 0 |
| 0 | x | |
Note:
1.Different Vendor’s Router will have different appearance of setting.
2.Once you set the DMZ Host, you don’t need to configure the Port Forwarding and vice versa.
3.If there is only one SP5001/S attached to the IP Sharing device, it is recommended to use DMZ Host setting to enable the NAT traverse and disable the Port Forwarding.
4.If there are two or more sets of SP5001/S attached to the IP
5.After the IP Sharing configuration of SP5001/S and IP Sharing device is complete, you must reboot SP5001/S to activate the new settings.
59
