MicroNet Technology SP5001/S user manual Sysconf, System information command list

19.7.11 [sysconf]

This command displays system information and configurations.

usr/config$ sysconf

System information and configuration Usage:

sysconf [-idtime digit] [-bf digit] [-keypad dtmf] [-faxtype type][-2833type type][-lcdrop ON/OFF] [-droptime digit][-eod digit]

sysconf -print

-print	Display system overall information and configuration.
-idtime	Inter-Digits time.(1~10 sec)
-bf	BusyForward.(ON:1 / OFF:0)
-keypad	Select DTMF type: 0=In-band,
	1=RFC2833.
-faxtype	FAX Payload Type	(range:96~128
inter-used:100,102~105)
-2833type	RFC2833 Payload Type (range:96~128
inter-used:100,102~105)
-lcdrop	Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0)
-droptime	Period of Loop Current Drop (ms)
-eod	End of Dial Digit setting(0: none, 1: *, 2: #)
Example:

sysconf -keypad 0 -eod 2

usr/config$

Figure 52. system information command list

Parameter Usages:

-print	print current settings
-idtime	set the duration (in second) of two pressed digits in dial mode as
	timed out. If after the duration user hasn’t pressed next number,
	LAN Phone will dial out all number pressed.
-bf	Only working in Proxy mode.
-keypad	DTMF relay type. When value is “1”, SP5001/S will transfer
	DTMF signal via RTP payload as defined in RFC2833. When
	the value is set to “0”, the DTMF type is set as In-band.
-faxtype	FAX Payload Type. Range: 96~128 inter-used:100,102~105.
-2833type	RFC2833 Payload Type. Range: 96~128
	inter-used:100,102~105.
-lcdrop	Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime	Period of Loop Current Drop (ms).
-eod	to define end of dial digit. (0: none, 1: *, 2: #).
	73