MicroNet Technology SP5001/S user manual System Commands Overview, Quit

19.7System Commands Overview

19.7.1[quit]

Type quit will quit configuration mode. And turn back to login prompt.

usr/config$ quit

Disconnecting...

login: root

Welcome to Terminal Configuration Mode Please enter your configuration item

Figure 37. quit command list

Note: It is recommanded that type the “quit” command before you leave the console. If so, SP5001/S will ask password again when next user connects to console port.

19.7.2[debug]

Open debug message will show up specific information while Gateway is in operation. After executing the debug command, it should execute command debug -open as well. One example is demonstrated below.

usr/config$ debug

Debug message information and configuration Usage:

debug [-add type1 [[type2]...]] -open -close -status

-status	Display the enabled debug flags.
-add	Add debug flag.
-delete	Remove specified debug flag.
-open	Start to show debug messages.
-close	Stop showing debug messages.
Example:

debug -add sip msg debug -open

usr/config$

Figure 38. debug command list

In this example, user open debug flags including sip, msg.

usr/config$ debug -add sip msg usr/config$ debug –open

64