Dual In-Line Memory Modules 105
„To print complex graphics or complex PostScript documents
„For increased collation performance
„For increased spooling performance
The magicolor 2210 has 3 DIMM slots available. Th e maximum memory
that can be installed is 384 MB (3 x 128 MB DIMMs).
„Check the startup page to make sure the printer has enough RAM
installed.
„If you have enough RAM installed, and you have configured the printer
from the control panel to print at 600x600 or 1200x1200 dpi resolution
(Administration/Engine/Def Resolution menu) but the printer continues
printing at a lower resolution, you may need additio nal memory allocated
to the frame buffer. (See the
CrownBook
for instructions.)
To allocate the defau lt amount of memory to the memory clients, use the
Administration/Memory/Quick Config menu to choose the correct
resolution and paper size for your printing.
If you experience a problem with your magicolor
2210, first go through the
installation procedure in this guide once more. Verify each item thoroughly.
You may also refer to the
User’s Guide
for troubleshooting tips. If you still
experience a problem, contact your local vendor or contact Customer
Service.
Installation
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before
performing this procedure, review the antistatic caution on page
105. In addition, always handle circuit boards by the edges only.
1If you are not to the point when you are able to print an advanced status
page yet, skip to step 2.
If you have previously installed your printer and have confirmed that it is
printing, print an advanced status page in case you need to restore any
memory settings after the DIMM installation.
Standard Memory Supports up to...
128 MB SDRAM DIMM 4-color 1200x1200 dpi simplex printing, at
basic performance, on all paper sizes up to
and including 8.5" x 14" (215 mm x 356 mm)
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500