Internal IDE Hard Disk Drive128

Installation
Attention
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage . Before performing
this procedure, review the antistatic caution on page 105. In addition,
always handle circuit boards by the edges only.
When installing or removing a hard disk, make sure that the metal
support posts (on the hard disk) don’t hit any of the electrical leads on
the chips mounted on the controller board. The controller board will not
function if any of the leads are broken or shorted together.
1Ensure that the printer is turned off and the power cord and all interface
cables are disconnected.
2Loosen five screws from the controller
board and, using the tab on the lower side
of the panel, pull the controller board fro m
the printer.
3Position the controller board on a flat
surface so the controller board lies flat and
the interface panel is facing you.
4Attach the IDE hard disk to the hard disk
bracket.

Attach the IDE hard disk to the bracket with

the grooved-end of the bracket facing the

ribbon cable. The screw holes in the bottom

of the hard disk should match up with the

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500