SCSI Interface 125

Gently slide the controller board into the printer until it is fully seated, and
then tighten the five screws.
6Reconnect all interface cables.
7Reconnect the power cord, and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
8Print a startup page.
Check that the startup page lists the interface (Optional NIC) just installed
under “Options.”

Using a Network Interface

Once a network interface is installed, refer to the
Installation Guide
and the
CrownBook
for information on connecting to the network, installin g the
software, and configuring the interface and the network. You can also use the
documentation that came with the interface.

SCSI Interface

The optional SCSI interface allows you to connect up to three optional SCSI
devices, including a hard disk, and Jaz and Zip drives. These devices provide
storage for fonts, emulations, and other files; increase the number of pages
that can be collated; and provide a secondary storage area for spooled data,
while providing virtual memory capabilities.

What's in a Kit?

An optional SCSI interface kit includes the following:
SCSI interface card
SCSI interface card ribbon cable
Connector face plate
Two larger screws
Two smaller screws
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500