Internal IDE Hard Disk Drive 127

dSecure the SCSI interface card to the interface panel with the two
larger screws in the kit.
5Reinstall the controller board.
Gently slide the controller board into th e printer until it’s fully seated, and
then tighten the five screws.
6Reconnect all interface cables.
7Reconnect the power cord and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
8Print a startup page.
Check that the startup page lists the interface (SCSI) just installed under
“Options.”

Using a SCSI Interface

5"
Installing a SCSI interface allows the attachment of external SCSI
storage devices, such as hard drives, JAZ, and ZIP drives. Installing
the SCSI interface kit will not allow you to print via SCSI.

Internal IDE Hard Disk Drive

Attention
Make sure that the printer and all accessories are turned off before
installing accessories involving the controller board.
One optional internal IDE hard disk is supported on the GN model.

What's in the Kit?

The IDE hard disk kit includes the following:
IDE hard disk with ribbon cable attached
IDE hard disk bracket
4 screws
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500