Installing a Duplex Unit 107

Observe the keyed
side of the DIMM to
align it with the
connector. When
seated, the DIMM
stands upright, firmly in
place. If you cannot
snap the DIMM into
place, do not force it.
Reposition it, making
sure that the bottom of
the DIMM is seated
completely in the
connector.
4Repeat steps 5–6 for
each additional DIMM
that you install.
5Reinstall the controller board into the printer.
Gently slide the controller board into the printer until it is fully seated, and
then tighten the five screws.
When you print a startup page, verify that the total size of the RAM
installed in your printer is listed.

Installing a Duplex Unit

Read this section if you purchased a duplex unit for your magicolor
2210.
Kit Contents
Duplex unit
2 thumbscrews
Installation
1Remove the duplex unit from its shipping box.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500