Time-of-Day Clock 137

3Attach the time-of-
day clock to the
controller board.
Attention
Make sure that the pins on the time-of-day clock are properly aligned
with those in the receiving socket on the controller board. Damage
to the time-of-day clock and/or controller board could result if the
pins are misaligned.
aLocate the time-of-day clock socket on the controller board and the pin
1 notch or printed label.
bLocate the pin 1 indicator mark on the top of the time-of-day cl ock.
This mark may be a notch or a slight depression on one end of the
clock.
cAlign this indicator mark with the pin 1 notch or printed label on the
controller board.
dGently press down on the time-of-day clock until it’s firmly seated.
5Reinstall the controller board.
Gently slide the controller board into the printer until it is fully seated, and
then tighten the two screws.
6Reconnect all interface cables.
7Reconnect the power cord and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
8Print a startup page.
The time-of-day clock is not listed under “Installed Options” on the startup
page, but the time will appear as System Date in the Printer Information
column.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500