4 TV Operation and Features

27

Choosing a Viewing Source

Input Selection menu

Choose a viewing source from the Input Selection menu. The current TV input appears as a full-color icon in this menu.

1.Press INPUT to display the Input Selection menu. If there are only two inputs to the TV, INPUT switches between them without displaying the menu.

2. Highlight an input icon using

.

3.Press ENTER to switch to the input and close the menu.

More About the Input Selection Menu

To assign meaningful names to the icons, see the Inputs > Name menu in chapter 5, “TV Menu Set- tings.”

To rearrange the icons, see the Inputs > Order menu in chapter 5, “TV Menu Settings.”

Sleep Timer

The Sleep Timer turns the TV off after the length of time you set.

Setting the Sleep Timer

1.Press SLEEP on the remote control.

2.Press SLEEP additional times to increase the time in 30-minute increments up to the maximum of 120 minutes.

3.Press EXIT or wait five seconds without pressing any buttons for the message to disappear.

4.Press SLEEP to view the time remaining before the sleep timer turns off the TV.

Cancelling the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will disappear.

TV Tips

Turning the TV On or Off

To turn the TV on or off, point the remote control at the front lower-right corner of the TV and press the POWER button. Alternatively, press the POWER button on the side panel of the TV.

Controlling Sound Volume

Press VOL  / to adjust the sound level. See also “Controlling A/V Receiver Sound Volume” in chapter 2, “TV Setup.”

Changing Channels (antenna sources)

To change channels:

• Enter the channel number using the number keys on the remote control and press ENTER. For a two-

part digital channel, such as 3-1, press 3 1 to

CANCEL

enter a dash (separator).

Press CH/PAGE  /  to change channels one channel at a time.

Press and hold CH/PAGE  /  to move quickly through channels.

Press QV (QuickView) to switch back to the previ- ously tuned channel.

Press GUIDE to display ChannelView or TV Guide Daily (model LT-40134 only) channel listings, then highlight a channel, and press ENTER.

Repeatedly press FAV to cycle through channels setup as “favorites.” See chapter 5,“Setup Menu.”

To quickly add a channel to the favorites list, tune the TV to the desired channel, then press and hold the FAV key until the status display appears.

To remove a channel from the favorites list, tune to the channel (status display appears) and then immediately press CANCEL. See chapter 5, “Setup Menu” for more information.

NOTE: Memorize channels to make finding channels

easier. See the Setup > Scan menu.

Page 27
Image 27
Mitsubishi Electronics LT-40133 manual Choosing a Viewing Source, Sleep Timer, TV Tips