Monessen Hearth BWBC400I, BWB400I manual Glass Door Installation and FAN Accessory

GLASS DOOR INSTALLATION AND FAN ACCESSORY

GLASS DOOR INSTALLATION

This fireplace has been tested and listed for use with optional Model GD36P or GD36PB glass doors. For installation of the Models GD36P or GD36PB glass doors, see the instructions provided with the doors.

FAN ACCESSORY

The model BWBC400 and BWBC400I Fireplaces may be equipped with a Model FA2 fan accessory. If the fireplace is to be equipped with the FA2 fan at anytime, the JB1 junction box assembly must be installed on the fireplace as shown by Figures 32 and 33 during the installation of the fireplace. Unless the JB1 junction box is installed at this time, wall finishing materials must be removed to gain access to the side of the fireplace to install the JB1 junction box at a later date. Complete Installation and Operation Instructions are included with the FA2 Fan.

Note: A rectangular switch knockout is provided on the lower right hand face of the fireplace.

MODEL JBI JUNCTION BOX INSTALLATION

FIGURE 32

FASTEN MODEL JBI JUNCTION

BOX TO THE SIDE OF THE

FIREPLACE WITH THE TWO

SHEET METAL SCREWS REMOVED

FROM JUNCTION BOX

OPENING COVER.

NOTE: THE THREE PRONG RECEPTACLE

AND ITS COVER MUST BE EXPOSED AND

THE COVER PLATE MUST BE REMOVABLE

FOR INSPECTION OF WIRING CONNECTION

ONCE THE FIREPLACE IS INSTALLED.

REMOVE JUNCTION BOX COVER FROM FIREPLACE.

GAS APPLIANCE

OPENING COVER

JUNCTION BOX

OPENING COVER

BELK LOUVER KIT

FIGURE 33

M1	M2
(FAN ASSEMBLIES)	CORDSET
	120V, 60HZ
	SWITCH
	(SPST)

JUNCTION BOX

OF FIREPLACE

	BLACK	TO FUSE OR
	WHITE
		CIRCIUT BREAKER
GROUND

NOTE: THE JBI-JUNCTION BOX SHOULD BE INSTALLED AND THE RECEPTACLE WIRED TO THE ELECTRICAL SYSTEM OF THE STRUCTURE AT THE TIME OF INSTALLATION OF THE FIREPLACE OF THE FA2 FAN ASSEMBLY IS TO BE USED.

28

53D9031. Rev 1 03/03