Multiquip LS600P operation manual ENGINE components

ENGINE components

			13
6	7	8	4	14
5		9
4		10
			12
3			15
2		11	16
			17
1			18
			19

Figure 8. Perkins 1104D-44TA Diesel Engine Components

The engine (Figure 8) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturer's engine manual for instructions and details of operation and servicing.

1.Crankshaft Pulley — Check fan V-belt between V-Pulley and alternator to determine proper belttension.

2.Water Pump — Circulates coolant flow through engine block.

3.V-Belt— Driven by the engine crankshaft during operation, drives the water pump/fan as well as the alternator.

4.Alternator — Provides power to the electrical system. Replace with only manufacturer's recommended replacement parts.

5.Front/Rear Lifting Eye — When lifting of the engine is required attach a strap or chain of adequate lifting capacity to these lifting points.

6.Oil Filler Port/Cap –— Remove this cap to add engine oil to the crankcase. Fill with recommended type of oil as specified in the maintenance section of this manual

7.Air Cleaner — Prevents dirt and other debris from entering the fuel system. Remove clamps on air filter canister to gain access to filter element. Replace with only manufacturer's recommended type air cleaner.

8.Air Intake Port — Attach the air filter hose to this port.

9.Secondary Fuel Filter — Prevents dirt and other debris from entering the fuel system. Service the fuel filter as recommended in the maintenance section of this manual.

10.Fuel Injection Pump — Provides equal fuel flow to injectors.

11.Oil Filter — Spin-on type, filters oil for contaminants.

12.Flywheel — A rotating gear attached to a driveshaft.

13.Muffler — Used to reduce noise and emissions. DO NOT touch muffler when engine is running. Allow muffler to cool before performing maintenance.

14.Turbocharger — Provides pressurized intake air to the cylinder by means of a turbine energized by exhaust gas that rotates the blower.

15.Dip Stick — Remove dipstick to determine if the engine oil level is low. If low, add oil as specified in Table 4.

16.Oil Pan — Reservoir for engine oil. Capacity is 2.08 gallons (2.5 liters).

17.Starter/Solenoid — This engine uses a 12VDC, 2.7kW (3.7 HP) starter motor with solenoid.

18.Oil Drain Plug (2) — Remove to drain crankcase oil. Always dispose of used oil and oil filters in an environmentally safe manner. DO NOT allow used oil to drain onto the ground or into a water runoff drain.

19.Primary Fuel Filter — Prevents dirt and other debris from entering the fuel system. Service the fuel filter as recommended in the maintenance section of this manual.

page 28 — MAYCO LS600P CONCRETE PUMP • operation manual — rev. #0 (05/13/13)