operation
4. | Reinstall the control panel and tighten the 2 retaining |
| screws. |
5. | On the top of the unit, to the right of the control box |
| (Figure 37), hammer out the |
Remote pumping operation can be performed by the hand- held radio remote control (Figure 39).
ON
the remote antenna. |
OFF
PUMP PUMP
POWER LED
ANTENNA
HOLE
ANTENNA |
|
CONNECTOR | REAR OF |
CABLE | CONTROL BOX |
| CONTROL BOX |
| CONNECTOR |
Figure 37. Antenna Installation
6.Connect the antenna cable to the connector on the rear (Figure 37) of the control box.
Radio Remote Control Buttons Operation
Before the remote control
LOCALREMOTE
CENTER
OFF
Figure 38. Pumping Control Switch (Remote)
REV ON/OFF
BATTERY LED | VOLUME VOLUME |
NOTE: OLDER MODELS
MAY INDICATE FLOW
INSTEAD OF VOLUME
Figure 39. Radio Remote Control
The buttons on the
ON/OFF – Turns the power on or off.When power is on the power LED lights red. If the battery LED turns red, 9V battery needs to be replaced.
PUMP ON/OFF – Starts and stops the forward pumping. PUMP REV – momentarily pumps in reverse direction. VOLUME (+) – used to increase the pumping volume. VOLUME
MAYCO LS600P CONCRETE PUMP • operation manual — rev. #0 (05/13/13) — page 37