Multiquip LS600P operation, Starting Procedure, Place the cylinder stroke control switch in the

Starting Procedure

WARNING

DO NOT attempt to operate this concrete pump until the Safety, General Information and Inspection sections have been read and understood.

1.Locate the emergency stop switch (Figure 20) on the digital control panel. Turn the emergency stop switch clockwise and release (open). This will allow the engine to start.

				n	c
			e			y
		g
	r						S
	e
	m						t
							p
E							o

operation

4.Place the direction control switch to the FORWARD position (Figure 23).

FORWARD REVERSE

Figure 23. Direction Control Switch

(FORWARD)

5.To start the engine, insert the ignition key (Figure 24) into the ignition switch and turn the key to the ON position.

ON

OFFSTART

Figure 20. Emergency Stop Switch

NOTICE

If the emergency stop switch is in the closed position (STOP), engine will not start. To start the engine, make sure the emergency stop switch is in the OPEN position (fully extended).

2.Place the cylinder stroke control switch in the

AUTOMATIC position (Figure 21).

AUTOMATIC JOG

Figure 21. Cylinder Stroke Control Switch

(Automatic)

3.Place the pumping control switch in the CENTER OFF position (Figure 22) for normal pumping operation.

LOCALREMOTE

CENTER

OFF

Figure 22. Pumping Control Switch (OFF)

IGNITION

Figure 24. Ignition Switch

6.When the ignition key is in the ON position, the digital readout screen (primary) will cycle through 3 displays as shown in Figure 25.

LS 600 OFF	1
0000 ENG RPM
BATTERY 12.5 V
LOW OIL PSI
	1
LS 600 OFF
0000 ENG RPM
BATTERY 12.5 V
LOW RPM FAULT
	1
LS 600 OFF
0000 ENG RPM
BATTERY 12.5 V

END OF MESSAGE

Figure 25. Primary Screen (Ignition Key ON)

7.Turn the key to the START position and listen for the engine to start. In warm weather let engine warm up for 5 minutes. In cold weather, let engine warm up for 10 minutes.

MAYCO LS600P CONCRETE PUMP • operation manual — rev. #0 (05/13/13) — page 33