Multiquip LS600P pump components Continued, Engine — Perkins 1104D-44TATurbo Diesel engine

pump components (Continued)

Figure 6 illustrates the location of the major components for the LS600P Concrete Pump. The function of each component is described below:

15.Documentation Box — Contains engine and pump operation, parts and maintenance information.

16.Remixer Motor — Drives the remixer paddles inside the hopper. The motor direction is controlled by the remixer control lever.

17.Hopper/Hood — Lift hood to fill. Concrete from a Redi-Mix truck is poured into this hopper. The hopper can hold 10 cu. ft of concrete with optional forward/ reverse mixer. NEVER put hands or any other parts of you body into the hopper.

18.Hydraulic Oil Sight Glass — Use to determine the amount of hydraulic oil remaining in tank. The sight glass also contains a temperature gauge for monitoring the temperature of the hydraulic oil.

19.Hydraulic Oil Tank/Cap — Remove cap to add hydraulic fluid. Fill with Shell Oil Tellus 68 or Mobil Oil DFE26 if level is low.

20.Hydraulic Oil Filter — This in-tank return hydraulic filter with a 10 micron cleanable filter is designed to remove all particles large enough to cause wear and job break down. Under normal conditions, replace every 6 months.

21.Control Box — Contains the electrical components required to run the pump. See control box components section for component callouts.

22.Hydraulic Pump — This unit incorporates an axial variable displacement hydraulic piston pump.

23.Engine — Perkins 1104D-44TA Turbo Diesel engine.

24.Radiator — Fill only with recommended coolant. Radiator coolant capacity is 4.5 gallons (17 liters).

25.Volume Control — This device is electronically controlled by the cylinder stroke switch located on the front panel of the control box. The function of the volume control is to set the pumping stroke.

26.Lubrication Box — This box is empty when shipped from the factory. Please fill with 3 gallons (11.35 liters) of SAE 30 motor oil for first time use. Also check the dual clean-out point on bottom of lubrication box for a secure tight fit.

27.Heat Exchanger — The function of the heat exchanger is to cool the hydraulic oil when pumping in high temperature weather conditions.The exchanger draws oil from the hydraulic tank through a filter and into the heat exchanger before allowing it to flow into the hydraulic system.

28.Accumulator — Stores hydraulic oil under pressure and releases it to the shuttle cylinder and provides the pressure needed to ensure enough force is provided during cycle.

29.Hydraulic Stabilizer Control Lever (Right) — This feature is an option. Push the lever downward to extend the left hydraulic stablizer. Push the control lever upward to retract the stablizer.

30.Hydraulic Stabilizer Control Lever (Center) — This feature is an option. Push the lever downward to extend the right hydraulic stablizer. Push the control lever upward to retract the stablizer.

31.Remixer Control Lever (Left) — Controls the forward/ reverse motion of the hopper remixer paddles.

32.Hopper Discharge Sleeve — Connect hoses or steel pipes to the discharge sleeve for pouring concrete.

33.Rear Running Lights — ALWAYS check and make sure both the right and left running lights are functioning correctly before towing the pump

MAYCO LS600P CONCRETE PUMP • operation manual — rev. #0 (05/13/13) — page 25