N150 4-Port Wireless Router JNR1010

If you select the Private check box, the static route is not reported in RIP.

4.Select the Active check box to make this route effective.

5.Type the destination IP address of the final destination.

6.Type the IP subnet mask for this destination.

If the destination is a single host, type 255.255.255.255.

7.Type the gateway IP address.

The gateway IP address must be a router on the same LAN segment as the N150 4-Port Wireless Router.

8.Type a number from 1 through 15 as the metric value.

This value represents the number of routers between your network and the destination. Usually, a setting of 2 or 3 works, but if this is a direct connection, set it to 1.

9.Click Apply to add the static route.

Remote Management

The remote management feature lets you upgrade or check the status of your N150 4-Port Wireless Router over the Internet.

To set up remote management:

1. Select Advanced > Advanced Setup > Remote Management.

Note: Be sure to change the router’s default login password to a secure password. The ideal password contains no dictionary words from any language and contains uppercase and lowercase letters, numbers, and symbols. It can be up to 30 characters.

2.Select the Turn Remote Management On check box.

Advanced Settings

80

Page 80
Image 80
NETGEAR JNR1010 manual Remote Management