NETGEAR XM128 ISDN manual Description of ATI3 Output, SPID0, SPID1, Spid?, Upx

		Reference Guide for the Model XM128 ISDN Digital Modem
Table C-1.	Basic AT command set (continued)
Command	Options	Function and description
SPIDn=m		User enters Service Profile ID (SPID) m, for USA switches.
	SPID0	First SPID number
	SPID1	Second SPID number, if any.
SPID?		Display the SPID setting(s).
UPX		Download firmware to the flash EPROM using X-modem Protocol.
Vn		Sets display type for result codes. See also S-register 23.6. For a description
		of Extended S-registers, refer to Table D-4 on page D-5 in Appendix D, “Status
		Registers and Result Codes."
	V0	Displays result code in numeric form. See also S-register 35.7 and the result
		code table of ATXn. For a description of Extended S-registers, refer to
		Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."
	V1 *	Displays result code in verbose form.
Xn	n=0-7	Result code options. See the options table. See also S-registers 23.3 to 23.5.
	5 *	For a description of Extended S-registers, refer to Table D-4 on page D-5 in
		Appendix D, “Status Registers and Result Codes."
Zn	n=0-4	Resets the Model XM128 modem and sets power-on profile. See also
		S-registers15.5 to 15.7. For a description of Extended S-registers, refer to
		Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."
	Zn	Resets the Model XM128 modem and loads user profile n (0-3).
	Z4	Resets the Model XM128 modem and loads factory settings.
$		Basic command summary help

Description of ATI3 Output

The Link Status Report output is displayed on the screen as follows:

NETGEAR ISDN Modem LINK	STATUS REPORT
Connect DTE Speed	:
Error Control Level	:
Protocol Link Speed	:
Octets Received	: 0
Octets Sent	: 0
Cause	:
Cause Value	: 0
HDLC FCS Error	: 0
HDLC Receive Over-run	: 0
HDLC Transmit Under-run	: 0

AT Command Set Reference C-7