NETGEAR XM128 ISDN manual Register Descriptions, Table D-3 Basic S-registers ATSn=x

Reference Guide for the Model XM128 ISDN Digital Modem

S-Register Descriptions

In most bitmapped S-registers, the default bit value is 0 (which is the normal situation) and only the nondefault situation is described. Some reserved bits are for factory use, and the user should not change them. Table D-3 describes each basic S-register. Values followed by an asterisk (*) are the factory default settings.

Table D-3.	Basic S-registers ATSn=x
Command	Function and description	Default
S0=	Sets the number of rings on which the Model	000
	XM128 modem answers; 0 value disables
	auto-answer.
S1=	Counts and stores number of rings from an	000
	incoming call.
S2=	Defines escape code character, default [+]	043
	(43 dec.).
S3=	Defines ASCII carriage return.	013
S4=	Defines ASCII line feed.	010
S5=	Defines ASCII backspace.	008
S7=	Sets duration, in number of seconds, that the	060
	Model XM128 modem waits for a carrier.
S8=	Sets duration, in seconds, for the pause and	002
	repeat commands. For more information, refer
	to Table C-1 on page C-2.

D-4 Status Registers and Result Codes