2Procedures for
1 Turn on the camera and
After turning on the camera, press the [ON/OFF] button on the
•The red
•Make sure that
MODE | A B |
NOSEL
READY
LO
2 Setting the flash mode on the
Press the [MODE] button on the
3 Activating or canceling the
Press the [AB] select button to set the remote flash units in Group A or B to fire or to cancel.
• A remote flash unit on the left as viewed from the
•A flash canceled group indicator disappears.
•You cannot cancel flash firing for both Groups A and B.
4 Setting the flash output level compensation (in TTL BL or TTL mode)
Press the [SEL](FUNC.), or [] or [] button to display the flash output level compensation value (blinking). Press the [] or [] button to increase or decrease the compensation value. Press the [SEL](FUNC.) button once again and the value will stop blinking. The last value to blink is the one that has been set automatically.
• The same value is set for both groups A and B.
• Flash output level compensation values can be set in 1/3 step increments or decrements from +3.0 to
• The values are displayed in decimal format, like 0.3 for 1/3, and 0.7 for 2/3.
• Pressing the [] or [] button continuously increases or decreases the value quickly.
• The compensation value blinks during adjustment and stops after blinking six times unless an adjustment is made. The last value to blink is the one that has been set automatically.
• If the flash output level compensation value is set 0.0, the display goes off.
• Being able to set flash output level compensation is
112
dependant on camera in use.