If the red ready-light blinks immediately after shooting

W

 

SPEEDLIG S R

IRE

LES

 

HT S

ON/OFF

In the TTL mode, when the SB-R200 flash has fired at its maximum output and underexposure may have occurred, the red ready-light on the SB-R200 blinks for approx. 3 sec. (The ready-lights on the SU-800 and in the camera’s viewfinder do not blink.)

To compensate, set a higher ISO sensitivity or use a wider aperture and reshoot.

In the M (manual) mode, set the manual flash output level for Groups A and B.

Press the [SEL](FUNC.) button to display the manual flash output level (blinking). Press the [] or [] button to increase or decrease the value. Press the [SEL](FUNC.) button once again and the manual flash output level stops blinking. The last value to blink is the one that has been set automatically.

• Manual flash output level can be set separately for each group.

• Manual flash output level can be set in 1 step increment or decrement from M1/1 to M1/64 output level (M1/8 is preset when shipped from the factory).

• Pressing the [] or [] button continuously increases or decreases the value quickly.

• Manual flash output level blinks during adjustment and stops after blinking six times unless an adjustment is made. The

last value to blink is the one that has been set automatically.

Detailsshooting

close onprocedures up-

operation flash and

73