2 Attaching the SB-R200 to the front of the lens.

1 Attach one of the Adapter Rings to the front of the lens.

Five types of Adapter Rings with different diameters (ø52mm, ø62mm, ø67mm, ø72mm, and ø77mm) are provided.

• Turn the Adapter Ring securely until it stops.

• These rings cannot be used together with other lens filters.

AF Micro-Nikkor 105mm f/2.8D is shown in the illustration.

2 Press the Attachment Ring SX-1’s Mounting Buttons on both sides to attach it to the Adapter Ring, then release.

• Make sure that the Nikon logo (p. 24) on the SX-1 is on the under side facing down.

• Use fingers of both hands to press the two Mounting Buttons on both sides to attach the SX-1 securely.

Make sure that the SX-1 is not attached at an angle. If it is, remove and reattach.

3 Slide the SB-R200’s Mounting Foot into the SX-1’s Mounting Groove as shown, then slide the lock switch.

L

The Mounting Foot cannot be inserted in

K

 

OC

reverse.

 

Slide the lock switch until it stops and make sure that the red part can no longer be seen.

 

Move the SB-R200 slowly by

 

4 holding down the Release Buttons

 

on the SB-R200’s Mounting Foot

L

until it comes to the desired

K

 

OC

position. Release the Release

 

 

Buttons to secure.

 

There are click stops every 15° on the

 

Attachment Ring.

R1 the using operation Flash

47