5 Setting the SB-R200’s flash output level ratio between groups A and B (in TTL mode). Press the [SEL](FUNC.) button to display flash output level ratio (blinking), then press the [] or [] button to increase or decrease the ratio. Press the [SEL](FUNC.) button once again and the flash output level ratio stops blinking. The last value to blink is the one that has been set automatically.

•The flash output level ratio can be set from 8:1 to 1:8.

•As the ratio changes, the flash output level indicator bar varies.

•Continuously pressing the [] or [] button quickly increases or decreases the ratio.

•The flash output level ratio blinks during adjustment and stops after blinking six times unless an adjustment is made. The last value to blink is the one that has been set automatically.

6 Setting the SB-R200’s flash output level compensation value (in TTL mode).

Press the [SEL](FUNC.) button to display the flash output level compensation value (blinking). Press the [] or [] button to increase or decrease the compensation value. Press the [SEL](FUNC.) button once again and the flash output level stops blinking. The last value to blink is the one that has been set automatically.

•The same flash output level compensation value is set for both Groups A and B.

•The flash output level compensation values can be set in 1/3 step increments or decrements from +3.0 to -3.0 EV.

•The values are displayed in decimal format, like 0.3 for 1/3, and 0.7 for 2/3.

•Continuously pressing the [] or [] button quickly increases or decreases the value.

•The flash output level blinks during adjustment and stops after blinking six times unless an adjustment is made. The last value to blink is the one that has been set automatically.

and operation flash up-close on Details procedures shooting

71