NordicTrack CTK65020 user manual Incline Rainer, Trainer

H OW TO	S ET	U P THE	INCLINE	T RAINER
Assembly requires two persons.		Set the INCLINE TRAINER in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed.				Assembly can be completed using the
included allen wrenches.

Note: The underside of the INCLINE TRAINER walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect INCLINE TRAINER performance. If there is lubricant on top of the walk- ing belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. Slide the Right and Left Uprights (96, 107) onto the
brackets near the front of the Base Frame (52).		Make
sure that the Uprights are on the correct sides; the
indicated holes must be facing the INCLINE
TRAINER.
Raise the Left Upright (107) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket as shown. Thread an Upright Bolt (106) into the
Upright and the bracket.	Do not fully tighten the
Upright Bolt yet.

Repeat this step with the Right Upright (96).

2.While a second person holds the Handrail (94) near the Uprights (96, 107), feed the wires in both sides of the Handrail down into the Uprights. Pull the ends of the wires out of the lower ends of the Uprights and remove

the wire ties from the ends of the wires.

Finger tighten four Handrail Bolts (93) into the Handrail

(94) and the Uprights (96, 107) as shown. Be careful to avoid pinching the wires in the Handrail.

Note: The CD Holder (143) and the Cup Holder (10) are replaceable. If these parts become dislodged from the

Console (89), simply press them back into place.

3.Connect the Right Upright Wire Harness (105), the TV Cable (33), and the Left Upright Wire Harness (131) in the indicated locations. Push all of the excess wire up

into the Uprights (96, 107).	Make sure that all wires are
fully connected. Note: Regardless of which console
your INCLINE TRAINER has, connect all wires so that
the console can later be upgraded if desired.
Refer to step 1. While a second person holds the
Uprights (96, 107), remove the Upright Bolts (106). Slide
the Uprights fully onto the Base Frame (52).		Be careful
to avoid pinching your hands or the wires.

196

107

Holes

106		52
			106
			52
2			89
		143	10
	93	94
			93
96			Wires
			107
3		96
			107

105

33 131

7